Apply decals in a dry environment with the regulator applied to mask

STEP 1: Clean the area thoroughly with soap and water. Do not use Windex or similar products because it will leave a residue behind that will prevent the sticker from adhering well.

STEP 2: Prepare the sticker for application by firmly rubbing a squeegee, credit card or finger across the clear transfer tape. This removes any air bubbles that may have formed and makes the sticker cling to the transfer tape.

STEP 3: Place regulator on mask. This will show you where to place the decal on the mask and not block the regulator heads up display.

STEP 4: Peel the white paper backing off the sticker. If the sticker clings to the backing, slowly replace the paper backing and repeat Step 2.

STEP 5: Center and lower the decal onto the surface just above the heads-up display. Rub it in place firmly with a squeegee, credit card or finger.

STEP 6: Slowly peel the transfer tape off at an angle. Be careful not to pull the decal off the surface. If decal pulls away, replace the transfer tape and press the decal firmly to the mask. Slowly remove transfer tape again.